Pager System for Wireless Calling System with 30 Coaster Pagers for Restaurants etc.

(Customization Logo)

TRANSMITTER

DIMENSION: 235*158+36mm

MATERIAL: ABS

TRANSMIT POWER: 480mW

STANDBY POWER: 650mW

MAXIMUM POWER: 18W

FREQUENCY: 315MHz

POWER SUPPLY: DC12V/2A

LAUNCH DISTANCE: >800M OPEN AREA

SUPPORT RECEIVER: 99(30/SET)

IP GRADE: IP32

RECEIVER

DIMENSION: 103*51*10mm

MATERIAL: ABS

RECEIVING SENSITIVITY: -114dB

STANDBY POWER: 148mW

LI-POLYMER: 3.7V/150mAh

FREQUENCY: 315MHz

RECEIVING DISTANCE: >800M OPEN AREA

STANDBY TIME: ≈ 6HOUR

PROMPT MODE: VIBRATION BEEP FLASHING

IP GRADE: IP32

1.Open the package

Connect the power adaptor to the power supply to charge the pagers for 10-20 minutes, then you can do the Pagers ID Pair.

2.PagerslDPair

Press the Pager's Function Button (take down the plastic cover and AD card paper, you will see the buttons) at center and Cancel button at the flank at the same time, then the 2 red indicator lights on the right side will be on, thus the pager enters the lD pair mode. Then input the corresponding matching lD number and Press the Call button on the keypad of transmitter, the pager will vibrate and beep, which means they have paired successfully. If you input the wrong number, just press the Delete button on keypad to delete the wrong number and input again.

3.Pager Prompting Time Length

Every time you press the Function button, are indicator light will be lighted on, and every 12 seconds of the prompting time will be lengthen. It can be lengthen to 60 seconds at most. When all indicator lights went out, pager’s prompting time is 60 seconds, and the beep mode (sounds mode) will be turned off only vibration mode is left.

4.TurnOn-0ff

Press the Function button for several seconds, the pager will be powered off with vibration and indicator lights will go out. Then put it back to the corresponding charges lot.

AlsoyoucanpresstheFunctionkeyshortlytoturnthepageron."Onenumber" to turn off all receivers: In put the 99 on the keypad of transmitter and press the Call button, then all receivers will be powered off. Also, you can reconnect the device to the power supply to turn on all pagers again.

5.Delete the Paired ID Number and Re-Pair

Follow the instructions of “Pagers lD Pair" to pair the pagers number again, the new lD number will cover the registered one automatically.

6.Reset the Transmitter (keypad) lD of JT-912

Keep pressing the “Call" key of keypad and reboot your system. The screen will flicker, then input a new lD and just press "Call” key again to save, the new lD will auto cover the previous one. You can set a same lD number to 2transmitters or more to let one pager could pair and work with Mult-transmitters at same time.

Note:*All pagers lD also need to re-pair after you reset the transmitter ID.”

Note:

1. Delivery can be expedited with additional freight cost

2. Stock availability/ Actual order lead time will be rechecked once confirm order

3. We do not accept returns or exchanges for indent item unless product quality issue

4. Picture shown is for illustration only, actual product may differ

5. This image is representative of the product range, actual product may differ

6. Product may vary slightly from image representation

7. Please allow 1-3mm error due to manual measurement

8. Stock availability subject to prior sales