Selleys Liquid Nail Mirror and Aluminum 9555086301196

Selleys Liquid Nail Mirror & Aluminium 75g

A premium grade, high strength construction adhesive that has non-corrosive properties when being used on mirrors. Most other construction adhesives do not have this capability and will de-silver the mirror. Liquid Nail Mirror & Aluminum is heat and steam resistant which is important when fixing mirrors to walls in Bathrooms.

Ideal for: Mirror, Aluminium, Metal, Steel, Glass

Features:

• Heat & steam resistant
• High temperature & UV resistant
• Will not discolour mirrors
• Strong vertical hold
• Non-corrosive
• For interior & exterior use

Direction:

• Ensure the surface is sound, dry, and free from oil, grease and dust.

Application for mirrors:

• For mirrors up to 6mm thick, apply strips of adhesive approximately 8cm apart. Do not apply adhesive within 5cm of mirror edge.
• Immediately after applying adhesive, place mirror against wall before adhesive skins (within 5 minutes).
• When mirror is pressed onto the wall, strips of adhesive must not spread into, or touch one another. A gap must remain between them.
• Hold in place with temporary supports (e.g. with clips or tape) to maintain adhesive contact over the total bond area until sufficient adhesive strength has developed (normally after 72 hours).
• Do not seal around the edges of the mirror for at least a week to allow air circulation.
• Mirrors should not be fixed directly to unpainted timber, plaster, concrete or brick walls. These surfaces should be painted to prevent potential damage to mirror.

General Application:

• Painted surfaces should not be flaky or peeling. Freshly painted surfaces should be allowed to dry for at least 7 days, before job is done. Test for compatibility on painted surfaces, before using.
• Not for permanent water immersion.
• Not for rigid bonds (eg. broken glass).
• Adhesive requires air to cure.
• Clean up while wet with mineral turps.

Safety tips

• On contact, uncured sealant can irritate eyes.
• If in eyes, flood with water for at least 15 minutes and seek medical advice.
• Avoid contact with skin. If contact occurs, wipe off immediately and wash with detergent. May irritate sensitive skin.
• Avoid breathing vapours.
• Ensure use in a well ventilated area, product releases methyl ethyl ketoxime while curing.